UFH Type without Keyway, Regular & Short Version - Inch (Imperial) Bores Timken 68514413859

UFH Type - Flange-to-Shaft

A flange-to-shaft configuration, this couples flange mounted equipment to a shaft with all the benefits of Uniflex versatility. The stock flange plate is the same as used on the UF Type.

The one-piece UFH Type coupling is similar to the U Type, except that one hub is replaced by a flange plate. Stock flange sizes are shown in the Dimensional Data table below but other sizes can be made to order. As with the other Uniflex styles, this coupling compensates for high degrees of angular and parallel misalignment with very little backlash or windup and is reliable in harsh or severe environments.

Regular and short versions are available for each size to accommodate different overall length requirements. For increased versatility, the hub can be modified with a tapered, spline, hex or square bore. The standard hub is furnished with either a pre-drilled pin hole or with a keyway and set screw. Specify when ordering.

Note: The UFH Type coupling does not come with assembly hardware. Assembly hardware must be purchased separately.

Specifications

Dimensional Data

Performance Data

Coupling Design

Notes